Installing MQRB4236 Liner Panels
There are several types of Liner Panels available for the MQRB4236:
-
Flat Black Back Panel and False Bottom- (Supplied with Unit).
-Porcelain Back and Side Panels-
MQRB42PL
Removal of False Bottom and Back Panel
1. Remove four [4] screws from False Bottom and lift out of the Firebox (
Ref.1
).
2. The Back Panel is held in place by the False Bottom and 2 Locking Tabs on the inside top of the Firebox (See
Ref.2
Below).
Once the False Bottom is removed, slide the bottom of the Back Panel forward until it releases from these Tabs and then
remove it from the firebox.
Installation of MQRB4236 Liner Panels
1. Remove 2 DT Screws from Firebox sides (Do not discard these screws). Place Side Panels into Firebox as shown in
Ref.3
below; tilt and slide into place. Replace and tighten DT Screw through hole in top of Side Panel and into side of Firebox.
2. Install Back Panel
(Be sure Flange is facing outward as per Ref.1)
.Engage Slots into Locking Tabs in Firebox Top as
shown (See
Ref.2
above).Slide Back Panel into place.
3. Place False Bottom over burner system(Pilot Ember Shield must be attached on Pilot side) and fasten with four [4] screws.
Ref.1
Pilot Shield
Flange Out
Ref.2
Slot for
Ref.2
Note: Warping and Discoloration of
Porcelain or Painted Metal Liners Is Not
Covered Under Warranty.
Both Porcelain and Painted Metal Liners
may discolor and warp during normal
operation of your appliance. This is normal,
and not considered a defect
.
31
