IDV34 / IDV44
Burner Installation/Removal
Burner System
1. Remove glass door assembly and logs (if installed). Be careful with logs as they become fragile after being heated.
2. Remove log supports off burner assembly.
3. The burner or burner assembly can now be removed.
a. TO REMOVE H-BURNER/ORIFICE CHANGE - Remove the two [2] screws holding the H-Burner in and slide
it leftwards off the orifice.
b. TO REMOVE BURNER ASSEMBLY - Locate and remove the twelve [12] screws around the outside of the
burner pan. This will remove the entire burner assembly.
4. When removing the entire burner assembly, break the seal and lift upwards. Make sure the gas line to the unit has
been disconnected.
5. To reinstall the burner assembly ensure the surfaces are cleaned, and old sealant material removed. Use high temp
Millpac to seal and secure with the twelve [12] screws.
6. Reconnect the gas line, and reinstall log support, logs, and glass door.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
42
Summary of Contents for Capri IDV34 Series
Page 46: ...Gas Conversion for Modulator PART C 46...
Page 59: ...Proflame 2 Remote Control 59...
Page 61: ...61...
