Marquant 442055, Operating Instructions Manual

Page: 29 / 31

ENGLISH
29
same time to all the connected products within range. This shows that the smoke detector is working
properly. You can also do a test with artificial smoke.
Setting/connecting
Setting as host unit: When two or more products are connected, press the learn button once. The red/green
status light changes colour once. Set host units to the mode for green status light. Setting as slave: Set
slave units to the mode for red status light.
Connected
1. When the correct setting is made, keep the test button on the host unit pressed until the red alarm
status light and the red/green status light for connection/learn flash continuously and a wireless alarm
signal is given.
2. When a slave unit receives a signal from the host unit the status li ght for learn mode flashes
continuously and an alarm is given at the same time by all the connected units. The red status lamp
goes off.
3. When the required units are connected, press the test button on one of the alarm units. The other
connected products gi ve an alarm and the status lights flash continuously.
Removing
Press the learn button on the unit to be removed, to put the unit in the mode for green status light. Press
the test button to enable normal alarm mode. The red status light for alarm and the red/green status light
for connection/learn flash continuously to show that the product has been removed.
Installation (see diagrams)
1. Choose a suitable place to install
within range of the other units.
2. Use the mounting plate as a
template and mark out and drill
holes in the ceiling. Insert plugs
in the holes.
3. Screw on the mounting plate.
4. Align the two hooks on the
mounting plate to the slots in the
base. Turn the plate clockwise
so that the hooks slot in place.
5. Carry out a communication test
after completing the installation.
MAINTENANCE
1. Test the product every week.
2. Clean the appliance every month. Remove the batteries before cleaning. Check the connection with
the test button after cleaning.
3. If the product is not working properly, check the batteries.
4. Replace the batteries with new batteries of the same type. Pair Deer 9V 6F22, GP 9V 1604S,
Mustang 9V 6F22, Pair Deer 9V 6LR61, GP 9V 1604A, Pair Deer 3 x 1.5V LR6/AA, GP 3 x 1.5V
GP15AU, Mustang 3 x 1.5V LR6/AA
5. Contact your dealer if you cannot rectify the problem by using the troubleshooting chart.