Trawl Explorer | V5 | Sensor Configuration
1.
Before /
2.
Turn 90° to the right /
3.
After /
4.
Card slot
1.
Turn to 90° the transducer as shown on the picture.
2.
With an Allen key, screw back the transducer.
4.
Reconnect components.
1.
Up & Down connectors /
2.
Uplink
connector /
3.
Uplink LED
1.
Connect the uplink LED cable to the uplink
LED connector.
2.
Connect the up (B), down (A) and uplink (C)
cables and add silicone glue.
3.
Reconnect the batteries.
Tip:
If you have a doubt, the cable
types are written on them and their
location is written on the PCBA.
4.
Put back into place the PCBA retainers and
screw with the 1.5 mm Allen key.
What to do next
You need to change the end cap orientation.
Changing the End Cap Orientation
Procedure
1.
Remove the end cap.
1.
Remove the four screws maintaining the end cap with the 1/8"
Allen key.
28
