Procedure
1. Remove the old pressure sensor.
a. With the flat screwdriver, remove the screw
above the pressure sensor.
b. Remove the components from the hole of the
end cap:
i. Remove the spring and metal ring with
tweezers.
ii. From the inside, push the pressure
sensor and its cables out with a small
screwdriver or Allen key.
iii. Remove the o-ring seals and adapter
ring with tweezers.
c. Fully clean the surface and hole from debris
(with a swab or Q-tip) and inspect the surface
for burrs or pitting.
1.
Screw /
2.
Spring /
3.
Metal ring /
4.
Pressure sensor /
5.
Small o-ring (1mm thick) /
6.
Adapter ring (metal, must be installed with grove-side up) /
7.
Large o-ring (1.5mm thick, may
stay in the bottom of the hole when pressure sensor is removed) /
8.
Pressure-relief symbol:
look for this symbol before installing
2. Install a new pressure sensor.
CAUTION:
Always use the install tool to set the pressure sensor in place.
Never directly insert the spring and screw with the pressure sensor or
you may damage the pressure sensor.
CAUTION:
Never push the pressure sensor from the outside with your
finger or any tool to put it into the hole. Pressure sensors have a thin
membrane that is very fragile and pressing it will damage the sensor. The
install tool correctly place the pressure sensor at the bottom.
XXL bottle
| V1 | Replacing Parts
23
Summary of Contents for Pro Trident XXL bottle
Page 1: ......
