LONG REACH AIR GAP FAUCET
WITH 3/8" CONNECTOR
Figure 2
3. Assemble and attach the Faucet (Refer to
Fig. 2 above.)
•Assemble the Body and Spout by removing
the plastic shipping plug from the Body and
then firmly pressing in the Spout.
•In the following order, place the Face Plate
(Escutcheon) on the 7/16" stud.
•From the top of the counter place the stud
through the mounting hole.
•From the bottom of the counter top, in the fol-
lowing order, assemble the steel Slotted
Washer, the Plastic Spacer (with open end
upwards), the 7/16" Washer and the
7/16" Hex Nut.
•To the end of the 7/16" stud screw on the 3/8"
Polytube Quick Connect Fitting. Once snug by
hand take a pair of pliers and tighten the fitting
an additional half turn. Don’t over tighten.
•Rotate the Spout and Body into position. Align
the Split Washer and the Spacer to allow
access to the Hose Barbs, and tighten the
Hex Nut while holding the faucet in alignment
with a padded Crescent wrench. Do not over
tighten.
B. Feed Water Saddle Valve Installation
Decide on location. Do NOT connect to a hot
water feed line. If you are not sure of the supply,
run the hot water and feel the supply piping. Water
over 100˚F may cause permanent damage to the
R.O. Membrane. (Refer to Fig. 3 below.)
FEED WATER SADDLE VALVE
Figure 3
1. Shut off the water supply and drain the line.
2a. To install on (soft) Copper Tubing supply line:
• Turn the Handle of the Feed Water Saddle
Valve counter clockwise (outward) until the
lance does not protrude from the gasket. It
may have to be pushed in.
• Assemble the Feed Water Saddle Valve on
the tubing.
– for 3/8" OD tubing use the back plate side with
the small groove to prevent distortion of the
tubing.
– for larger tubing (up to 5/8" OD) use the large
groove of the back plate.
• Assemble and tighten the brass screw.
Spout
Plastic Shipping
Plug (Remove)
7/16" Stud
Face Plate
(Escutcheon)
Mounting
Surface
Plastic Spacer
7/16" Washer
7/16" Hex Nut
3/8" Polytube
Quick Connect
Fitting
3/8" Blue Polytube
CL
Slotted Washer
Air Gap Window
Critical Level
Line
Reject Outlet For
Drain Clamp Line
Reject Inlet For
Manifold Drain Line
Cold Water
Line
Saddle
Valve
Handle
Insert
Plastic
Ferrule
Tubing To
Manifold
Inlet
Compression
Nut
Tightening
Screw
Reversible
Back Plate
