INSTALLATION & OPERATION MANUAL, GAS TILTING SKILLETS,
MODELS: 30P-STGL, 30P-STGL-LX, 40P-STGL, 40P-STGL-LX,
30P-STGM, 30P-STGM-LX, 40P-STGM, 40P-STGM-LX
SECTION 5, TROUBLESHOOTING AND MAINTENANCE
REPLACEMENT OF TEMPERATURE CONTROL
1.
Place circuit breaker in off position.
2.
Remove skirted dial knob by loosening two set screws in the knob. (Use a 5/64 Hex key to
loosen screws).
3.
Tilt control box up by first removing two pan head screws in the lower front of the console.
Use the prop up arm located inside, in the rear vertical column, to keep the console cover
tilted open.
4.
Disconnect all wire leads from temperature control.
NOTE:
Leads should be marked appropriately to facilitate re-installation.
5.
Remove temperature control by removing two (2) pan head screws from side of control
box.
6.
Install new temperature control and reverse steps 1 - 5.
ADJUSTMENT OF INTERLOCK SWITCH
1.
Tilt skillet pan all the way in the downright position.
2.
Place circuit breaker in off position.
3.
Tilt control box up by first removing two pan head screws in the lower front of the console.
Use the prop arm located inside, in the rear vertical column, to keep the console cover
tilted open.
4.
To reduce the angle where the switch disengages when the pan is tilted, use a pair of
heavy duty needle nose pliers and lightly bend the tilt tab on the trunnion up. To increase
the angle, bend the tilt-tab down. Test by tilting the pan and checking at what angle the
switch clicks. The switch should click off at approximately 10
E
tilt of the pan from the
horizontal position.
5.
Close and fasten the control console by tightening the two screws at the lower front of the
box.
6.
Place circuit breaker in on position.
Part No. 10158R3
19
2019-05-24
