4-7
Nº326S Preamplifier
Controls & Modes
8. When the desired adjustments have been made, press and
release the
balance button
to close the
balance
control.
Otherwise, the
balance
control automatically closes a few sec-
onds after the last command is received. If this occurs, the
selected setting is automatically applied.
9. Press and release the
mono button
to cancel
L + R
mono
playback and return to stereo playback.
L – R Phono Alignment
L – R
mono playback simplifies the process of aligning phono
Tip
cartridge azimuth.
To use L – R mono playback to align phono cartridge azimuth:
1. Press and hold the remote control
mono button
until the
MODE
parameter opens on the front panel display as shown
to the left.
2. Press and release the
mono button
to cycle through all
available
MODE
parameter settings until the
L – R
mono
mode is selected as shown to the left.
3. Press and release the front panel or remote control
enter
button
to close the
MODE
parameter.
Otherwise, the
MODE
parameter automatically closes a few
seconds after the last command is received. If this occurs, the
selected setting remains selected.
4. When the
MODE
parameter is closed, press and release the
remote control
mono button
to activate
L – R
mono playback.
5. Begin playback of the desired mono recording.
6. Using the
L – R
output signal, adjust the associated phono
cartridge azimuth to achieve minimal output signal.
Playing a mono recording when
L – R
mono playback is acti-
vated should result in silence (no output signal). Because
phono cartridges differ, it is recommended to adjust azimuth
to achieve minimal output signal.
7. Press and release the
mono button
to cancel
L – R
mono
playback and return to stereo playback.
MODE: L + R
MODE: L – R
