To teach Nº326S IR commands to a learning remote control:
1. Prepare the learning remote control to receive IR commands.
2. Follow the instructions on page 3-2 to open the
setup menu
.
3. Rotate the front panel
select knob
or press the remote control
select ± buttons
until
Teach IR
is selected.
4. Press the front panel or remote control
enter button
to open
the
Teach IR
menu.
The
VOLUME UP
IR command will appear on the front panel
display.
5. Rotate the front panel
volume knob
or press the remote control
volume ± buttons
to scroll through all available IR commands.
6. When the desired IR command is selected, press the
enter
button
to teach this command to the learning remote control.
The
SENDING -->
message will appear on the front panel dis-
play as shown to the left to indicate that the associated
infrared signal is being sent to the learning remote control.
7. Repeat steps 5 and 6 until all desired IR commands have been
sent.
Note
The Nº31, Nº31.5, Nº37, Nº39, and Nº390S remote
controls can be used to control Nº326S master volume level.
This command is available over IR (not Link connections).
Before using one of these remote controls to adjust Nº326S
master volume level, make sure the digital transport setup
menu volume control parameter is set to fixed.
3-10
Setup Menu
Mark Levinson
SENDING -->
