BULLETSENSE 1050/RL1100 INSTRUCTION MANUAL VERSION 1.2
6
Station 8 Setup and laser Alignment (For use with Powder check):
NOTE: On RL 1050, and some very early model Super 1050, the mirror bracket can not be mounted
on the rocker bolt due to a raised ledge in the casting. For these units only the primer stack tube
can be used. Please refer to Station 7 Setup.
1.
Refer to the Mounting Configurations section on Page 4 to make sure the sensor assembly is
configured properly to sense in Station 8. In the Station 8 configuration, the mirror is mounted
off a remote mount to the right of Station 3. This is how the product is factory configured.
2.
Hold the primer rocking assembly in place with your finger or a pry bar and remove the shoulder
bolt, see Figure 5. Place the split washer on the longer shoulder bolt supplied with the Station 8
hardware and fasten the mount to the frame, see Figure 6.
Figure 5: Remove the shoulder bolt to mount on station 8 adapter.
Remove
Hold
Hold
