BULLETSENSE 1050/RL1100 INSTRUCTION MANUAL VERSION 1.2
10
Figure 9: Direct beam over the tip of the bullet (left) the reflected beam will hit the back side of the bullet (Right)
Figure 10: Properly orientated Bullet- Beam interrupted (Left) Improper orientated Bullet
–
Beam not interrupted (Right)
11.
Once the proper height has been achieved ensure the 2X brass set screws are tightened and
tighten the shaft locking collar, see Figure 9. The shaft locking collar is used to lock in the
required height adjustment. If you need to remove the BulletSense® assembly for press
maintenance or for any reason you can choose to remove the upper mount only. When re-
installing, the vertical position will be maintained.
Brass Thumb Screws
Shaft Locking Collar
