7
6
INSTALLATION
Tank Preparation
1. Locate unit near a 110–120 volt grounded
outlet with a 20 amp dedicated circuit.
2. Make sure Vented Panel is not obstructed.
(To avoid overheating, we recommend
keeping an adequate distance between
the vent and any barriers for ventilation.)
These panels allow cooling air to reach
compressor. They also provide access
to filters, thermostat, on/off switch, drains
and other components.
3. Unpack all accessories, supplies and upper
false bottom from tank. Remove plywood
used for shipping support.
4. Remove Vented Panels. Make sure system
components are plugged into junction box.
5. Connect Foam Drain Tube (see exploded
view Pg. 5) to Drain Outlet or Skimmer Cup.
Because the Foam Drain Tube is designed to
drain off excess liquids and foam from display
tank, you will need to locate tube over a
container or floor drain.
6. Set thermostat (see exploded for location) 50° F.
See page 17 for loading temperatures.
WARNING:
Do not attempt to operate unit on
extension cord or non-grounded circuit.
Do not handle or connect plug with wet hands.
The following simple steps are required to get your system up and operational.
Consult exploded view (Pg. 5) for any necessary clarification.
