46
DEFECT
CAUSE
SOLUTION
Sand in the pool.
If the sand fill is new, the grains
in it are smaller then set size.
Repeat the back washing ope-
ration several times, until the
backwashing water is clean.
Sand in six-way valve (residues
from backwashing).
Set the position “Backwashing”
and pump water to drain for
approximately 30 seconds.
The partition dividing the
chamber for cleaned water is
not correctly installed.
Check installation correctness
of the partition.
Bottom screen is damaged.
Change the bottom screen.
Leaks at hose connections.
Leaks at seating faces of hose
connections.
Re-stuff the hose studsusingte-
flon tape.
Only specialised company is allowed to carry out repairs on pumps.
Note: After certain type of operation in connection with wear of mechanical seal
between the pump chamber and motor, you can see water leaks. This is standard
condition. If water leaks grow to intolerable level, have the mechanical seal changed.
Warranty conditions
This filtration device has been produced from high quality materials. All its compo-
nents were checked and found wholesome, the warranty period is 24 months from
purchase date. Keep all documents on purchase together with these Instructions
for Use. The invoice or bill is necessary for lodgement of any claim
• Claims are governed by Czech Law.
• Warranty covers any material or workmanship defects.
• We recommend to check completeness of the product when you buy it.
• After the purchase, check integrity of the transport packaging, condition of the
filtration device or other defects. In case of any damage contact your dealer
immediately.
• If you find any visible defects, which become apparent only after putting into ope-
ration and due to which it is not possible to use this device, you must contact your
dealer and lodge complaint without undue delay.
• When you find any defect on particular component, claim only the defective part.
The filtration device may be installed and operated according to the instructions
set herein.
