40
• pump (2) with drain screw (9)
• clear cover of pump suction chamber (8)
• connection flexible hose (3)
• valve (4)
• 2x hose stud (only one will be used)
• sealing:
– 2x O-rings for pump sockets
– sealing for pump suction chamber
• 2 screwed joints for assembly of the pump
• 1x hose clamp:
Technical data
Sand filtration equipment (400 mm filtration vessel), pump motor with coarse
pre-filter, 6- way valve and plastic base.
Flow rate
6.6 m³/h
Tension
230 V/ 50Hz
Power input
450 W
IP class
IP X4
Maximum water temperature
35°C
Sand fill
max. 17 kg
Grain size of filtration sand
0,6 - 1,2 mm
Weight without fill
Approx. 15 kg
Dimensions
69 x 46 x 33 cm
Max. working pressure
1,5 bar
Location of filtration device
Firstly select suitable place for location of filtration. Such a place should have even
base, with good access, protected from rain, sunlight and possible flooding. Do not
install the device in sumps, shafts etc. because there is high risk of flooding of elec-
trical pump. Select a place where at lease 10 cm space will remain behind the pump
motor for air supply to cool the motor. Also above the filtration and around it must
be sufficient space for inspections and maintenance. Near to the installation place
a single-phase socket meeting CSN requirements must be. If you use some exten-
sion cable, it must be of the type H07RN-F, with minimal core section 1 mm
2
.
Under the filtration unit we recommend to use some even (concrete, earthenware
etc.) plate of suitable size and under the pump a rubber pad should be placed to
damper vibrations and noise. Due to safety reasons install the filtration so that the
smallest distance from pool edge is 2 m. Suction and go-and -return pipe should be
led to be the most direct and is possible under gradient to the pump or valve. Big-
ger distance between the unit and pool and too complicated piping have negative
effect on filtration unit properties. Install the filtration unit under water level in the
pool with a pump located at the bottom of the pool (this is a flow pump).
