21
20
Problem treatment
Cause of Problems
Solution
Sand contaminated with dirt
Backwashing (cleaning of the sand)
Pump sucks air
(Bubbles at the inlet)
defective hoses,
tighten hose clamps
Skimmer or pump gets too little water
Check water level and increase if necessary,
check the intake for dirt accumulation
Skimmer basket contaminated
Cleaning of the skimmer basket
Prefilter basket of the filter pump contaminated
Cleaning oft he prefilter basket
To Winterize the System
At the end of the swimming season, the filter system and the hoses must be
removed and emptied.
This is done when the filter vassel as well as the filter pump by opening the drain
plug. Open the filter vessel and empty the filter sand. Verify that the filter sand is
still in reasonable condition (not glued or clumped) and clean it.
Filter systems located outdoors must be located in a frost-free room in the winter.
Care instructions
Visible contaminants are removed through the filtration system. This is not true
for algae, bacteria and other microorganisms, which are also a constant threat to
clear, clean and healthy pool water. For their prevention or removal, special water
treatment is available, properly and permanently dosed, guarantee for swimmers
any kind of harassment and ensure proper hygienic bath water.
Contact information
www.marimex.cz
+420 261 222 11
e-mail:
With every switching of the 6-way valve the filter
pump must be turned off!
Filter run time (2 x 4 – 5 hours a day) and the regular backwashing
(2 – 3 minutes) at least 1 x per week as well as the floorcleaning are
the basic requirement for maintained swimming pool water!
Repairs on the pump should only be performed by trained and qualified,
professional technicians.
Specifications:
All models:
6-way valve, filter pump TÜV / GS, filter vessel, connection Ø 32/38
mm, base plate
Model
ProStar 3
Flow rate:
3,8 m³/h at 0,4 bar working pressure
Connection:
230 V, max. 200 W
Amount of Sand:
max. 10 kg
Pool size:
max. 19 m³
Filter pump:
with prefilter, not self-priming
Floorcleaning (Illustration 8)
Floorcleaning is done in position FILTER (on the valve). The poolfloor vacuum
cleaner has to be connected with the pool-floor vacuum cleaner hose directly to the
skimmer. Until the pool-floor vacuum cleaner is connected and ready for operation,
the filter pump must be switched off.
Important: The pool-floor vacuum cleaner hose must fully be filled with water so
that the pump does not filter air, only then the pump can be switched on. Will air
get into the filter system, the filter pump is to turn off and the vacuum cleaner
must be vented again.
Now move slowly and smoothly (speeding can stir up dirt) with your vacuum
cleaning brush on the bottom of the pool.
For filter systems without prefilter a skimmer with a strainer basket is beneficial!
EN
Summary of Contents for ProStar 3
Page 1: ...Písková filtrace ProStar 3 Návod CZ SK DE EN HU PL ...
Page 17: ...32 ...
