MARIMEX Orlando Premium 10310019, Assembly Instructions Manual

Page: 91 / 144

91
The places which must be leaved
Do not place a pool at any of the following locations:
In proximity to areas and objects that are accessible to children or animals and which
can facilitate access to the pool. Otherwise, it is necessary to secure the surroundings
of the pool before children and animals enter the pool. On grass, rocks and roots.
Grass under the pool foil shakes and stones and roots damage the pool foil. Close to
trees and higher shrubs. Leaves and other dirt fall directly into the pool and increase
its pollution. Under the electric wires and the clothesline. In places with poor natural
water drainage. It may flood the pool area with water. On areas recently treated with
petroleum pesticides, chemicals or fertilizers. There is always a geotextile mat nee-
ded to be used below the swimming pool (not included in package).
Plan forward
Will you later add an adjacent platform? Leave space for her.
Know that the fool around you (trees, bushes) rises and the pool can be eclipsed.
IMPORTANT: If a sand filter, heat pump or other electrical equipment around the
pool is to be installed, it is necessary to select the location of the pool at the site so
that the device (filtering, heat pump, ...) can be installed 3.5 meters from the walls
of the pool. At the same time, it is also necessary to take into account the location
of the power supply (sockets) within the reach of the power cord of this device.
Sketches of building sites - see. Fig. 01.
A-B-C = poles with a flat upper end
D to K = measuring pins
10 = Pool wall; 11 = Swimming pool axis; 12 = Stakes / Center Stake; 13 = Pool area;
14 = Site area; 15 = Measuring pins; 16 = Base blocks
NOTE: The dimension P may be smaller than specified but sufficient to accommo-
date the underlying blocks. The distance M must always be greater than half the
longer dimension of the underlying block used
In continuous assembly, continue under part 2A or 2B
of the instruction
In swimming pool installation, continue to Part 2A for oval pool or 2B for circular
pool.
Part 2A – site preparation for the oval pool
IMPORTANT: The area under the pool must meet the following essential condi-
tions:
It must be horizontal, ie. within a tolerance of not more than 2.5 cm to the cross-
-section of the pool.
It must be provided with a thin layer of sifted sand, ie. (sandeel, hoe, ...) to cover
the entire area of the pool with a layer of not more than 2 cm.
It must be compacted, ie. so strong that a person weighing at least 80 kg does not
leave a visible trace on the surface.
Click the plate
Take a look at page 4 to prepare your site according to the sketch that matches
your pool type.
EN