TSM1330C User's Manual
Page 8
Revision 1.0
2.3.3 Arm Mounting
The TSM1330C is VESA (Video Electronics Standards Association) compliant and can be mounted
on an arm with a 75mm interface pad. To mount the TSM1330C on an arm, please follow the steps
below.
Step 1:
Please correctly mount the arm onto the base surface. To do this, refer to the installation
documentation that came with the mounting arm.
Step 2:
Once the mounting arm has been firmly attached to the base surface, lift the TSM1330C onto
the interface pad of the mounting arm.
Step 3:
Align the retention screw holes on the mounting arm interface with those in the TSM1330C.
The arm mount retention screw holes are shown in Figure 3.
Step 4:
Secure the TSM1330C to the interface pad by inserting the retention screws through the
bottom of the mounting arm interface pad and into the TSM1330C.
Figure 3
– TSM1330C VESA Arm Mounting Retention Screw Holes
NOTE
When purchasing a mounting arm please ensure that it is VESA compliant and that
the arm has a 75 mm interface pad. If it is not VESA compliant, it cannot be used to
support the TSM1330C.