11
RT-9 Start up
On the initial start-up, there will be two panels enabled. There will be a “1” in the lower left corner,
pressing this will allow you to control the content of panel 1. There will also be a “2” in the bottom
center of the screen, pressing this will allow control the content of panel 2. If the same content for two
adjacent screens is selected, the selection will seamlessly fill both screens. In the SETTINGS menu panels
can be added or subtracted. To open a third panel, go into SETTINGS and under PANELS select “3”.
Press one of the panel numbers for that corresponding Panel menu to open.
o
Change Panel Source
Exactly what will be shown will depend on which modules are installed on the
ports, and which ports they are in. There can be a module in each port, but only
two may be the same. (i.e. 2 Sonar modules or 2 camera modules) A sonar
module in port 1 will show in the Panel Source Menu as “Marcum Sonar: 1”; a
sonar module in port 2 will show in the Panel Source Menu as “Marcum Sonar:
2”. A camera module in Port 3 will show as “SD Camera: 3”
o
Navionics map
Allows either the stock map or a downloaded Navionics map chip to show
o
Picture
Allows a stock or saved image to show, this is a nice option for a background
when using sonar or for occupying an empty panel. To display sonar over a
picture select Sonar first, and then choose a background picture.
o
Solid Color
Set the background to a solid color of your preference. This option is only
available for Sonar mode. Select Sonar first and then choose the background
color you would like. Solid Color will not work with a Map or Camera displayed
in the panel.
o
SD Camera
Selecting this will allow video to be viewed in that panel.
This option is only available if a camera module is attached to one of the ports.
o
Marcum Sonar
Selecting this will allow that panel to display the Sonar you have chosen.
This option is only available if a sonar module is attached to one of the ports.
