8716P Hybrid NVR Installation Guide
28
Unit Setup
Wall-Mounting the Recorder
Wall-mount the recorder unit using the brackets provided in the wall-mounting kit. The wall-
mounting kit is not included with the recorder: it must be purchased separately.
WARNING:
Ensure that the location where you wall-mount the unit can fully support the unit’s weight. For
information about the weight, see “Specifications” on page 12. To ensure the unit does not exceed the
recommended operating temperature, the unit must be wall-mounted in a location where it is
unobstructed on all sides.
ATTENTION :
Assurez-vous que l’endroit où vous fixez l’appareil au mur peut supporter pleinement son
poids. Pour plus d'informations sur le poids, voir « Specifications » à la page 12. Pour garantir que l'unité
ne dépasse pas la température de fonctionnement recommandée, l'unité doit être fixée au mur dans un
endroit où elle n'est pas obstruée de tous les côtés.
To wall-mount the unit, attach the brackets from the wall mounting kit (purchased separately)
directly to the recorder unit.
The following items are required:
•
Mounting screws
— pan head, sheet metal screw, #14 x 1.5 inch, steel, four (4) screws required
•
Drywall anchors
— four (4) anchors required, to use with #14 mounting screws
To attach the mounting brackets to the recorder
Use the pan head screws provided in the wall-mounting kit to attach the brackets to the recorder.
The following figure shows how the brackets are attached to the recorder.
Important:
The figure shows the recorder with the faceplate (front) facing down. The recorder can
also be mounted with the faceplate up, depending on which orientation is most convenient for you.
Left Screws
Back (rear panel)
Right
Left
Right Screws
bracket
bracket
Right
bracket
Front (faceplate)
