When the BALE MADE light comes on, it is time to tie off the bale and eject the bale
from the baler. See page 1-3 for control panel layout and location. See the following
page for a diagram of the following steps.
FOR BALE TIE OFF & BALE EJECT (HD MODELS):
1.
Depress the MANUAL UP button until the feed gate opens.
2.
Insert a large, flat piece of material across the top of the bale.
3.
Close feed gate and depress the AUTOCYCLE button. The platen
will stop in the down position and the BALE MADE light will be illumi-
nated.
CAUTION: CLEAR ALL PERSONNEL FROM FRONT OF BALER
BEFORE PROCEEDING WITH STEPS 4 THROUGH 8
.
4.
Release the bale chamber door latch on the side of baler and open
the bale chamber door all the way. Feed gate is closed but will raise
when the chamber door is opened.
5.
CAUTION:
Wear safety glasses and leather gloves during the follow-
ing operation:
Tie off bale by inserting bale ties through the platen, “loop end” first.
Always insert bale ties through the tie slots in the platen, first.
Feed wire through until it comes out of the slot in the baler floor.
Tie off each tie. Bale ties should be tightened only hand tight, allow-
ing for bale expansion when released.
6.
Standing at the side, make sure all personnel are clear of the front of
the baler. Depress the MANUAL UP button.
7.
Hold the MANUAL UP button until bale ejects, then release the
button.
8. Remove
bale.
9.
Close and latch the bale chamber door. Close feed gate. Depress
AUTOCYCLE to cycle and reset ejector. Bale sequence is ready to
be repeated.
1 OPERATION
OPERATING INSTRUCTIONS -
BALE TIE OFF/BALE EJECT FOR V-6030HD, V-4830HD, V-7230HD
1-9
