Paths to be confirmed
Display
Settings
What to confirm
15
Back DAC-Height2 (signal) Path
L1
A 2 0 S B - H 2
L2
* * * . * d B
Input Source : CBL/SAT
Input Mode:Auto
Sound mode: Multi ch Stereo
Amp assign:11.1ch
Floor Layout : 5ch&FW
Height Sp : 4ch
Dolby Sp : None
Height Layout : Top Front & Top Rear
Speaker Select = Floor & Height
MAIN ZONE : ON
ZONE2 : OFF
ZONE3 : OFF
・Analog input ⇒ RCA output → Height2 L/R (Top Rear output)
(* The input source can be switched to any source except CBL/SAT.)
(* Volume -20dB is the value when Relative settings are used. The value is 60 when Absolute settings are used)
16
Height1 DAC-Height2 (signal) Path
L1
A 2 1 H 1 - H 2
L2
* * * . * d B
Input Source : CBL/SAT
Input Mode:Auto
Sound Mode: Multi ch Stereo
Amp assign:11.1ch
Floor Layout : 5ch&SB&FW
Height Sp : 4ch
Dolby Sp : None
Height Layout : Top Front & Top Rear
Speaker Config : All Small
Speaker Select = Front
Wide/Height2 XLR = Front Wide(AV7702 Only)
※ Special Settings:Height1 Path → Height 1 RCA/XLR Relay:Off Fixed
Height1 Path → Height 2 RCA/XLR Relay:On Fixed
Back Path → Back RCA/XLR Relay:On Fixed
Back Path → Height2 RCA/XLR Relay:Off Fixed
Wide Path → Wide RCA/XLR Relay On Fixed
Wide Path → Height2 RCA/XLR Relay Off Fixed
MAIN ZONE : ON
ZONE2 : OFF
ZONE3 : OFF
・Analog input ⇒ RCA output → Height2 L/R (Top Rear output)
(* The input source can be switched to any source except CBL/SAT.)
(* Volume -20dB is the value when Relative settings are used. The value is 60 when Absolute settings are used)
Note: For checking the signal path, in the A21 mode, voice of Height1 is output from RCA / XLR of Height2.
(Not output from any terminal voice of Height2 does not output the sound from the Height1 of RCA / XLR.)
fig.15a
fig.15b
fig.16a
fig.16b
27