WIRE FOR THE FLASHING RED LIGHT (LED)
Locate a hole into the passenger compartment from the engine compartment,
through which the LED wire will pass. If no hole can be found a new hole will have
to be drilled.
LED HOLDER
PULL
LIGHT
GROMMET HOLDER
TIGHTEN NUT
WASHER
DASHBOARD
FITTING THE FLASHING LED
Locate a point on the dashboard that can
be seen from the outside of the car.
Drill a hole in the dashboard just big
enough to tightly hold the flashing LED
holder (use a 10mm drill bit).
Remove flashing LED from the holder.
Push the LED holder into the dashboard
hole from the front and secure the holder to
the dashboard using the nut provided.
Refit the flashing LED into the holder,
ensuring that the grommet is pushed well
into the back of the holder.
Connect the wire from the LED to the
auxilliary connector.
When the red light is flashing your system
is armed, when it is not flashing the system
is disarmed.
DASHBOARD
FLASHING L.E.D.
NUT AND WASHER
TO ALARM
GROMMET
