ALARM INSTALLATION
X
X
3/32
”
A. MOUNTING THE ALARM
To install this sytem you must ensure your vehicle
has a 12V DC negative ground electrical sytem.
1. Remove alarm from metal bracket.
2. Locate a mounting area as high as possible in
the engine compartment allowing space at the rear
to allow for shock sensor adjustment.
WARNING:
DO NOT MOUNT NEAR EXHAUST
MANIFOLD OR OTHER HOT EQUIPMENT.
3. With a marking pen, mark the mounting holes for
drilling, using the metal bracket as a template.
4. Drill holes in the locations marked using 3/32”
drill bit.
5. Fix the metal bracket to the car using the screws
provided.
6. Refit alarm to the metal bracket.
7. Adjust the angle of the alarm and tighten the
screws.
