Supplied Accessories
●
Remote LED Indicator Module (with 2M cable) like the unit front panel.
●
4 heavy duty electrical eye connectors.
●
One plastic wire guide.
●
Double side sticker tape for the Remote Indicator Module.
●
Two thin wires for Pin Connections
●
One spare 8 Pin Connection sticker label
Installation Procedure
Do NOT install this unit in the
vehicle engine bay
.
This is a fan cooled electronic device not for use in high temperature, corrosive and dusty environment which
will drastically shortens the life and performance of the charger.
This charger is designed only for internal mounting and away from direct sunlight, heat and rain. Allow at
least 80mm of space at both ends for ventilation.
We recommend wiring by a qualified automobile electrician to ensure local safety and on-board standard are
followed
1.
To provide the best cooling effect, mount the unit in vertical position with the terminal end facing
downwards due to the top front exhaust design.
2.
First install the charger as close to the house battery as possible via a fuse.
3.
Check the LED indicators by a few presses on the Select Button.
4.
Before connect input to DC Alternator, check on type of alternator of car, for new car with smart
alternator select ether Vibration Sensor Mode or Ignition Feed Mode.
5. Do not charge LFP battery without built in Battery Management System.
6. Do not charge LFP battery below 0°C.& discharge below minus 5°C. Check with battery maker.
P.5
