Scissors Jack
Art. no. 009-T1000
Usage Instructions
Please read these usage instructions carefully and observe the warnings and safety information that they
contain.
Usage
This lifting jack is to be used exclusively for
lifting
vehicles with
a maximum weight according to the below mentioned technical
dates. This lifting jack is not to be used as a chassis stand for
lifted vehicles.
Technical Information
Max. capacity:
1500 kgs
Min. height:
100 mm
Max. height:
365 mm
Safety Information
•
Before each use, check the lifting jack for structural integrity and proper functioning.
•
Use the lifting jack exclusively for
lifting
the vehicle. Before beginning repair or inspection work on the lifted
vehicle, it must be secured with a proper a chassis stand.
•
The lifting jack is only to be used for lifting vehicles with a maximum weight according to the a/m chart. If this
capacity is exceeded, the lifting jack can be damaged, creating a danger of injury.
•
Determine the appropriate lifting point for your vehicle using the vehicle’s owner's manual.
•
The lifting jack is only to be used on a solid and level surface. Before lifting the vehicle, it must be secured such
that it will not roll away.
•
Do not use the lifting jack if there are people in the vehicle or leaning against the vehicle.
OPERATION
1. Before starting to work, secure your vehicle by activating the hand brake and wheel chocks to prevent the
vehicle from rolling away.
2. Position the lifting jack under the vehicle so that the lifting plate (1) will not damage the vehicle floor while the
vehicle is being lifted (observe instructions in the vehicle’s owner’s manual). Place it under a suitable part of the
frame or chassis.
3. Slowly lift the vehicle by turning the crank handle clockwise. While doing so, make sure that the vehicle does
not slip and that the lifting jack does not tilt or topple.
4. Once the vehicle is lifted high enough, it must be secured with a suitable chassis stand before beginning any
inspection or maintenance work under the vehicle.
5. Never use the lifting jack as a chassis stand.
6. In order to lower the vehicle, turn the crank handle counter-clockwise.
If you have any questions, please contact the manufacturer directly:
Brüder Mannesmann Werkzeuge GmbH
Repair / Service Department
Lempstr. 24
D-42859 Remscheid, Germany
Telephone:
+49 2191 / 37 14 71
Fax:
+49 2191 / 38 64 77
email:
