Tools Required
10mm Spanner
16mm Spanner
Care Instruction
Clean alloy tray prior to fitting the jack holder brackets.
Item Component Name
Qty Part No.
1
Holder Bracket - Bolt Type
1
C768
2
Holder Bracket - Clamp Type
1
C767
3
Swing Clamp
1
C769
4
M6 x 20mm Hex Bolt
4
B082
5
M6 Spring Washer
4
W004
6
M6 x OD12.5mm Flat Washer
4
W003
7
M6 Plate Nut
2
C838
8
M10 x 45mm Hex Bolt
2
B080
9
M10 Shakeproof Washer
2
W021
10
M10 x OD21mm Flat Washer
2
W005
11
Fitting Instructions
1
RS-451
5
7
6
4
1
2
8
9
10
3
Rhino-Rack
3 Pike Street, Rydalmere,
Document No: RS-451
NSW 2116, Australia.
Prepared By: Andy Wana
Issue No: 07
(Ph) (02) 9638 4744
Authorised By: Chris Murty
Issue Date: 11/11/2013
(Fax) (02) 9638 4822
These instructions remain the property of Rhinorack Australia Pty Ltd and may not be used or changed for any other purpose than intended.
Swing Arm Bracket
To be used at the base
plate end of high lift jack.
Page 1 of 2
43101 - Rhino Pioneer Jack Holder Bracket
Place these instructions in the vehicle’s glove box after installation is complete.
Important:
Please read these instructions carefully prior to installation.
Please refer to your fitting instruction to ensure that the alloy tray is installed correctly.
Check the contents of this kit before commencing fitment and report any discrepancies.
