www.mankati.com
19
ABS required ( Default: Extruder, 255
℃；
Build plate, 45
℃）
Preheat ABS Bed:
Preheat build plate to the working temperature of ABS required (
Default: Build plate, 45
℃
).
1.6 -
Leveling Bed:
Build plate calibration assist-function. Rotate the button, the extruder will
move to next position in clockwise direction in top view.
1.7 -
Cool down:
Cool down the extruder and build plate to normal temperature.
2 - Control:
Adjust printer settings
2.1 -
Temperature:
Nozzle:
Left temperature setup
Nozzle 2:
Right temperature setup
Bed:
build plate setup
Fan speed:
Cooling fan speed setup
Auto Temp:
All the above data setup automatically
2.2 -
Motion:
Please do NOT change any data in this menu if without specialist experience.
Accel: Accelerated speed of extruder motion
Vmax x:
Max speed in X direction
Vmax y:
Max speed in Y direction
Vmax z:
Max speed in Z direction
Vmax e:
Max speed of feeding motor
Vmin:
Min printing speed
VTrav min:
Min travel speed
Amax x:
Max accelerated speed in X direction
Amax y:
Max accelerated speed in Y direction
Amax z:
Max accelerated speed in Z direction
Amax e:
Max accelerated speed of feeding motor
A-retract:
Accelerated speed of retract
Xsteps/mm:
Transmission ratio of X motor
Ysteps/mm:
Transmission ratio of Y motor
Zsteps/mm:
Transmission ratio of Z motor
Esteps/mm:
Transmission ratio of feeding motor
2.3 -
Restore Failsafe:
Please do NOT change any data setting here in this menu.
2.4 -
Save memory:
Record the coordinate of printing stop
2.5 -
Restore factory:
Restore the manufacturer default settings
2.6 -
Firmware version:
Current firmware version
LCD Menu
Menus in Printing Process
During the printing, you can press the knob to change some printing settings.
1. Tune:
Re-set some parameters
-
F/R:
the actual printing speed takes the percentage of the pre-set speed in the software. It can be
adjusted while printing according to the actual situation.
-
Nozzle:
Temperature setup of left nozzle
-
Nozzle 2:
Temperature setup of right nozzle
-
Bed:
Temperature setup of build plate
-
Fan speed:
Fan speed setup
-
Flow: Filament feeding flow rate
-
Flow 0:
Filament feeding flow rate of left nozzle
-
Flow 1:
Filament feeding flow rate of right nozzle
-
Auto Temp:
Set all the above temperature automatically
-
Change filament:
To stop the printing and change the filament. It will record the printing stop position
so as to continue to print after filament changing.
2. Control:
Please do NOT change any data in this menu if without specialist experience.
3. Pause:
To stop the printing, but it will record the printing stop position to continue the printing.
4. Stop Print:
To finish the printing job