www.mankati.com
42
Even the screws under build plate have been loose totally, the build plate still is far away from the
nozzle (the gap between build plate and nozzle is too big to be adjusted).
A: Adjust Z axis limit switch on the back the printer, raise it a little bit; after adjusting, if problem
still exist, the main cause is deformation is not enough of the hot bed’s corners, it can be removed
by tensile processing.
The Z-axis movement of the build plate is abnormal.
1. The top of the Z-axis screw is loose.
Please reinforced screw at the top of the Z-axis screw.
2. Z-axis motor loose connections.
Please open the base to re-plug the motor cables.
3. Z-axis screw need lubrication.
Please add oil to the Z-axis screw.
Hardware Problems
Q:
A:
Q:
A:
Build Plate Problems