www.mankati.com
33
Feed the Filament
1.
Preheat the nozzle:
Choose ”Prepare”>”preheat
PLA ( or ABS)” on LCD.
Choose the nozzle you want
to preheat.
3.
Continue to feed the
filament in until it emerges
from the nozzle.
Note:
Please DO push the filament
GENTLY.
If filament attaches the nozzle, just
keep them attached, stop pushing
hardly. Otherwise, the nozzle
connection could be broken.
After the nozzle is preheated
enough, the filament will flow out
from nozzle naturally.
4.
Tighten the black screw
to fix the filament with the
clamp, making it not too
loose or too tight.
Caution:
1. Ensure the clamp is not too tight or too loose, otherwise, filament feeding will have problem causing failure prints.
2. After feeding successfully, check if filament has twining and knotting to ensure filament feeding smoothly.
3. Lubricate the XY axis and sliding blocks to avoid motion stuck.
2.
Feed the end of the
spooled filament into the
filament guide tube, where it
attaches to the extruder.