34
Part Number 4520898 Rev 7 11/15
Installation Instructions
INSTALLING THE COOKTOP OR WOK ASSEMBLY
Notice
To protect the induction equipment from water
penetration, you must apply and bond the silicone
adhesive properly to create a water-tight seal.
Before you begin the installation, it is very
important to use isopropyl alcohol (minimum 70%)
or equivalent to clean any surface areas where the
silicone adhesive will be applied.
NOTE: Countertop thickness of about 2mm is shown in
the illustrations as an example. Brackets and fasteners for
installation are not provided.
NOTE: Provide enough time for the silicone to cure per
manufacturer’s instructions. Do not start up the appliance
during this time.
To install the cooktop or wok assembly:
1. When Air Intake Kit is used, fasten the air duct flange
onto the cooling fan, which is located on the bottom
of the appliance. Fasteners (4 screws and 4 nuts) are
provided in the kit.
2. Apply silicone adhesive PACTAN to the counter surface
where the built-in mounting frame will sit. (PACTAN
part number 70000015, provided in the Air Intake Kit).
FLUSH-MOUNT
Method:
TOP-MOUNT
Method:
Summary of Contents for BH/IN 2500
Page 55: ......
