Manitou MT 732, Operator'S Manual

Page: 119 / 138

HYDRAULIC CIRCUIT DECONTAMINATION
- Let the I.C. engine run (accelerator pedal at halfway travel) for 5 minutes without using
anything on the lift truck, then for 5 more minutes while using completely the hydraulic
movements (except the steering system and the service brakes).
- Accelerate the I.C. engine at full speed for 1 minute, then activate the steering system
and the service brakes.
- This operation makes a pollution abatement of the circuit possible through the hydraulic
return oil filter.
E9 - SEAT BELT
CHECK
SEAT BELT WITH TWO ANCHORING POINTS
- Check the following points:
• Fixing of the anchoring points on the seat.
• Cleanness of the strap and the locking mechanism.
• Triggering of the locking mechanism.
• Condition of the strap (cuts, curled edges).
REELED BELT WITH TWO ANCHORING POINTS
- Check the points listed above together with the following points:
• The correct winding of the belt.
• Condition of the reel guards.
• Roller locking mechanism when the strap is given a sharp tug.
NOTE: After an accident, replace the seat belt.
Under no circumstances should you use the lift truck if the seat belt is faulty (fixing, locking, it has cuts or tears, etc). Repair or replace
the seat belt immediately.
E10 - N/A
- REAR AXLE DIFFERENTIAL OIL
DRAIN
MT 728 Série C-E2
MT 928 Série C-E2
Place the lift truck on level ground with the I.C. engine stopped and the differential oil still
warm.
Dispose the drain oil in an ecological manner.
- Place a container under drain plugs 1 (fig. E10) and unscrew the plugs.
- Remove level plug 2 (fig. E10) and filler plug 3 (fig. E10) in order to ensure that the oil is
drained properly.
- Refit and tighten drain plugs 1 (fig. E10) (tightening torque 30 ft/lb).
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by filler port 3 (fig. E10).
- The level is correct when the oil level is flush with the edge of port 2 (fig. E10).
- Check for any possible leaks at the drain plugs.
- Refit and tighten level plug 2 (fig. E10) (tightening torque 30 ft/lb) and filler plug 3 (fig. E10) (tightening torque 30 ft/lb).
E6/4
5
E10
3
2
1
1
1
3 - 33