Manitou M 26-2 Turbo Serie 3-E3, Operator'S Manual

Page: 159 / 178

3-51
LIFTING THE OVERHEAD GUARD OR CAB
Check that any object left in the operator’s stand cannot impede the operation.
- Slowly and slightly tilt the mast towards the front and release the support leg 5 (fig. G3/6).
- Continue lifting the overhead guard or the cab and insert the support leg in its end stops 6 (fig.
G3/7) at the earliest possible moment.
Do not raise the overhead guard or the cab more than necessary.
NOTE: The gear lever bellows will be turned inside out (according to model of lift truck).
- Slightly lower the overhead guard or cab to secure it in place (fig. G3/8).
LOWERING THE OVERHEAD GUARD OR CAB
- Tilt the mast forward slightly to release the support leg
and return it to its clip.
- Slowly lower the overhead guard or cab and check that
nothing impedes the operation
- Reinsert and tighten the silentblock fastening screws.
- Refit the side panels.
- Restore the gear box lever bellows to its correct shape
(according to the model of lift truck).
- Remove the cable, the eyes and refit the two screws on
the roof.
G4 - FRONT HEADLAMPS
ADJUST
RECOMMENDED SETTING
(as per standard ECE-76/756 76/761 ECE20)
4FU UP PG UIF EJQQFE CFBN JO SFMBUJPO UP UIF IPSJ[POUBM MJOF
of the headlamp.
ADJUSTING PROCEDURE
- Place the lift truck unloaded and in the transport position
and perpendicular to a white wall on flat, level ground (fig. G4).
- Check the tyre pressures (see: 2 - DESCRIPTION: CHARACTERISTICS).
- Put the gear reverser lever in neutral and release the parking brake.
CALCULATING THE HEIGHT OF THE DIPPED BEAM (H2)
tI )FJHIU PG UIF EJQQFE CFBN JO SFMBUJPO UP UIF
ground.
tI )FJHIUPGUIFBEKVTUFECFBN
tM%JTUBODFCFUXFFOUIFEJQQFECFBNBOEUIFXIJUFXBMM
G3/6
5
G3/7
6
6
h1
+%
-%
l
h1
h2
-2%
h2 = h1 - (l x 2 / 100)
G4
G3/8
647003 EN (03/01/2012)