Manitou M 26-2 Turbo Serie 3-E3, Operator'S Manual

Page: 133 / 178

3-25
B7 - HYDRAULIC OIL LEVEL
CHECK
Place the lift truck on level ground with the I.C. engine stopped and mast tilted backward and
lowered as far as possible.
- Refer to gauge 1 (fig. B7/1).
- The level is correct when it is mid-way between the two indicator marks.
- If necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL).
- Remove cap 2 (fig. B7/2).
- Add oil by filler port 3 (fig. B7/2).
Use a clean container and funnel and clean the underside of the oil drum before filling.
- Put the cap back.
- Check visually that there is no leakage in the tank and pipes.
Always maintain the oil level at maximum as cooling depends on the oil flowing through the
tank.
B8 - BRAKE OIL LEVEL
CHECK
Place the lift truck on level ground.
- Remove the front plate 1 (fig. B8/1).
- The level is correct when it is at the MAXI level on the tank.
- If necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by the filler port 2 (fig.
B8/2).
- Check visually that there is no leakage in the tank and pipes.
- Refit the front plate 1 (fig. B8/1).
If the braking oil level is abnormally low, consult your dealer.
B9 - WINDSCREEN WASHER LIQUID LEVEL
CHECK
- Open the I.C. engine bonnet.
- Check visually the level.
- If necessary add windscreen washer liquid (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by
filler port 1 (fig. B9).
B7/1
1
B9
1
B7/2
2
3
B8/1
1
B8/2
2
647003 EN (03/01/2012)