maniquick MQ770, Operating Instruction

Page: 32 / 52

CONDITIONS FOR SERVICE UNDER GUARANTEE
1. SANICO Srl guarantees the absence of faults and mechanical defects and the complete-
ness of the product when it is sold.
2. Repairs can be done only at Service Centres authorized by SANICO Srl or by the Authorized
Distributor in the country where you have purchased the appliance.
3. The duration of the period of guarantee on the materials and on manufacturing and operat-
ing defects is 2 years with effect from the date of sale, subject to all the conditions for the
Purchaser shown in the Instructions for use. The obligations of guarantee do not cover
expendable materials: electrode cups, elastic bands, power supply cables etc..
4. Complaints relative to the product must be presented directly to the authorized service cen-
tre. The service centre, on the basis of an agreement with the Vendor, is competent to
establish the cause and nature of the fault. The product will be replaced only if it cannot be
repaired.
5. The owner of the product will provide autonomously for delivering and collecting the product
from the place of the repair under guarantee.
6. The time necessary for the repair under guarantee will be subject to the degree of serious-
ness of the fault.
7. The responsibility of SANICO Srl under these conditions of guarantee will be limited to the
amount paid by the Purchaser for the product in question.
The guarantee on the product will not be applied in the following cases
• certificate of guarantee filled in incorrectly or falsified; serial number (if applicable for the
specific product) damaged or removed;
• absence of commercial and financial documents (cash receipt, delivery note) proving the
purchase;
• opening or repair of the product by the Purchaser or by an unauthorized Service Centre;
• defects following failure by the Purchaser to observe the rules for use, storage and transport
of the product shown in the relative technical and regulations documentation, in which case
the regulations of the aforementioned documentation which have been infringed must be
specified;
• penetration of foreign bodies or liquids inside the product;
• presence on the product of internal or external mechanical defects (cracks, signs of a fall,
chipped parts, etc.) consequent to the incorrect use, installation or transport of the product;
• components or accessories subject to rapid wear and tear (electrode cups, elastic bands);