Symptoms Possible cause / solutions
•
Check that the mains cable is plugged into the
power socket.
•
Check that your TV is configured for the correct
UHF channel or is switched to correct AV input.
•
No signal, check presence of signal.
•
Channel is scrambled.
•
Check tuning and programming parameters are
set correctly.
•
The antenna is not in correct position.
•
Check LNB wire is not damaged or shorting.
Check LNB may be faulty.
•
Unplug receiver from power socket and retry.
•
Local terrestrial TV interference, change the
receivers UHF output channel to different one
then re-tune your TV. Select the appropriate ‘TV
Standard’ using TV SETTINGS menu.
•
Signal weak or noisy. Check signal quality.
•
Antenna is not in correct position.
•
Check the batteries in your remote control.
Replace with new.
•
Apply master password or contact your
Manhattan dealer.
•
Receiver’s front display not lit.
•
Receiver is on but no picture or sound or any
menus.
•
Receiver is on but no picture or sound.
•
Interference on picture using UHF output.
•
Bad picture with blocking or frozen.
•
Receiver is not responding to remote control
•
You have lost or forgotten your password
Technical Specifications
TUNER
Input
Connector F-type
IEC
169-24
Female
Frequency
Range
950MHz
to
2150MHz
Input
Impedance
75
Ohm
Signal
Level
-25
to
-
65
dBm
LNB Power & Polarization
Vertical: +14V, Hori18V
Current:
600mA
Max.
with
Overload
protection
LNB Control
22KHz ± 4KHz, Tone burst A/B and DiSEqC 1.2
22KHz
Tone
Amplitude
0.6Vpp
(±0.2V)
Input
Symbol
Rate
2~45
Msymbol/sec
FEC Decoder
Auto, 1/2, 2/3, 3/4, 5/6, 7/8
SYSTEM
Transmission
Standard
DVB
MPEG-2
Input
Data
Rate Max
15Mb/s
Aspect
Ratio
4:3,
16:9
Video Resolution
720 x 480 NTSC, 720 x 576 PAL
Audio
Decoding MPEG
Layer
L
&
R
Audio Mode
Single channel / Dual Channel/Joint Stereo / Mono
Sampling Rate
32KHz, 44.1KHz, 48KHz, 96KHz
CONNECTORS
RGB, CVBS
2 x SCART sockets (TV/VCR)
1 X PHONO RCA
Audio Output
2 x SCART sockets (TV/VCR), 2 x PHONO (L, R) / RCA
Volume
and
Mute
Control
20
