If rotating the antenna becomes difficult, normal operation can be restored by lubricating the
bearing surface between the rotating gear housing and the base plate. Any spray type
silicone lubricant may be used.
Elevate the antenna and remove the set screw from the rotating gear housing (see
illustration). Spray lubricant into hole and around the edges of the gear housing. Rotate the
gear housing until the lubricant coats the bearing surfaces and the antenna rotates freely.
Make sure to check the operation of all exterior lights often. Check identification, clearance,
turn signal, brake, and backup lights to make sure they are working correctly. Replace burnt
out bulbs as soon as possible.
Clean with hot soapy water or a good liquid cleaner. Avoid using abrasive cleaners. Never
use steel wool on stainless steel, since the steel particles left in the sink can rust and become
unsightly. When cleaning stainless steel with a mild cleanser, rub gently with the grain, and
rinse well. Rinse after each use and wipe dry.
Be sure to remove all food and ice from the refrigerator at the end of each trip. Prop the door
open slightly to keep the interior dry, and free of mold, mildew, and odors.
Make sure to read all literature provided with each of the appliances, and follow the
maintenance instructions included. Pay particular attention to any cautions or warnings
included. Also read the rest of this manual, following the instructions for the care and use of
appliances.
NOTE: Do not place hot pans directly on countertop surfaces. Extreme heat can cause
scorching, and may also deteriorate the bonding agents which secure the countertop
to the base cabinets.
10-5
CARE & MAINTENANCE
2005 PRESIDIO
EXTERIOR LIGHTS
APPLIANCES, SINKS & COUNTERTOPS
Summary of Contents for 2006 Presidio
