Mamo LEGA 420, Manual

Page: 41 / 47

RE V. 2.2-12 /21 L EG A 420 37
soft Cover
(
image
a)
The book clamp takes the sheets to the cover gluing phase(3), the clamping table lifts until it touches the block to be bound, thenthe cover
gluing is performed and, after the closing time, the machine releases the bound book.
IMAGE A
hard Cover
(
image
b)
The book clamp takes the sheets to the cover gluing phase(3), the clamping table lifts but leaving a small gap available for the cover .
Then, the cover gluing is performed and, after the closing time, the machine releases the bound book.
IMAGE B
p. To proceed with another binding operation, repeat the instructions from c to f.
standby
If you need to stop a working cycle but wish to keep the machine running and the glue heated, press the STANDBY button on the
Main Menu page of the touch screen. The machine will keep the glue at standby temperature as set during installation (see paragraph:
ADJUSTMENTS).
To exit the standby functioning mode, press again the ALARM button and follow the instructions.
6.4 MACHINE DESCRIPTION
The machine is intended for use by a single user at a time, which must have received adequate information and training
6.4.1 u
ses not exPeCted
Unintended uses are all uses not expressly mentioned, and in particular stands out:
• Any use other than that for which the machine has been built is an abnormal condition and can cause damage to the machine
structure
• Use without the safety devices provided
• Failure to follow the procedures in this manual
• Use of the machine in the environment at risk of fire and explosion as it is not equipped with explosion-proof components
Pay attention to the photosensor, which controls the closing of the clamper.
The photosensor must not be obscured (see the photo-electric cell position in the picture below)
ENG
Ch A P T ER 7: M A IN T EN A NCE