![Mammooth M.DC.T.ID.20.45 Manual Download Page 17](http://html.mh-extra.com/html/mammooth/m-dc-t-id-20-45/m-dc-t-id-20-45_manual_699012017.webp)
EN
16
6) Changing over from 1st gear to 2nd gear (Fig. 7/ Item 7)
You can work at a higher or lower speed depending on the position of the selector
switch. To avoid damaging the gear unit you should only change over gears when
the tool has stopped.
7) Battery capacity indicator (Fig. 8– Item 2)
The 3 color LEDs will indicate the status of battery capacity as soon as you press
the ON/OFF switch (4). All LEDs illuminate: The battery is fully charged. The yellow
and red LED illuminate: The battery has an adequate remaining charge. Red LED:
The battery is empty, recharge the battery.
8) LED lamp (Fig. 8)
The LED lamp (10) can be used in poor lighting conditions to illuminate the area
where you want to drill or screw. The LED lamp (10) will be lit automatically as
soon as you press the ON/OFF switch (4).
9) Changing the tool (Fig. 9)
Important. Set the changeover switch (3) to its centre position whenever you carry
out any work (for example changing the tool, maintenance work, etc.) on the
cordless screwdriver.
• The cordless screwdriver is fitted with a quickaction chuck (9) with an automatic
spindle stop.
• Open the chuck (9). The chuck opening (a) must be large enough to hold the tool
(drill bit or screwdriver bit).
• Select the suitable tool. Push the tool as far as possible into the chuck opening
(a).
• Tighten the chuck (9) and then check that the tool is secure.
10) Screwdriving
We recommend using self-centering screws (e.g. Torx screws, recessed head
screws) designed for reliable working. Be sure to use a bit that matches the screw
in shape and size. Set the torque, as described elsewhere in these operating
instructions, to suit the size of screw.
TECHNICAL DATA
Sound and vibration
Sound and vibration values were measured in accordance with EN 62841.
L
pA
: sound pressure level 74.5 dB (A)
K
pA
: uncertainty 3 dB (A)
L
WA
: sound power level 89.2 dB (A)
K
WA
: uncertainty 3 dB (A)
Wear ear-muffs.
The impact of noise can cause damage to hearing. Total vibration values (vector sum
of three directions) determined in accordance with EN 62841.
Drilling in metal
Vibration emission value ah = 3.27 m/s2
K uncertainty = 1,5 m/s2
Screwing without hammer action
Vibration emission value ah <2,5 m/s2
K uncertainty = 1,5 m/s2
Voltage
supply
20V
0-400/0-1400
min
-1
19+1+1
Yes
2- 13 mm
Idling
speed
Torque
settings
Forward and
reverse
rotation
Chuck
Battery
charging
voltage
Battery
charging
current
Mains
voltage
for charger
Charging time
Weight
21 V DC
2400mA
220-240V~AC
50-60Hz
For 2.0Ah: 50 min
For 4.0Ah: 100 min
1.3kg