MegaPod User Instruction Manual
MaltaDynamics.com | 800-494-1840
10
8. INSPECTION:
Before each use, proceed with a thorough visual examination to ensure
that the PPE is intact (the same applies to the equipment used with the
harness (connectors, lanyard) and take all necessary steps concerning the
implementation of rescue in total safety. In the event of your product gets
contaminated, consult the manufacturer or authorized agent. If you have any
doubts regarding the safe state of the product or if the product has been used to
arrest a fall, it is essential to immediately withdraw the PPE from use and send it
to the manufacturer or a qualified repair center for checking or destruction.
Following the inspection, the center will provide written authorization or refusal
for the use of the PPE. Never attempt to modify or repair PPE.
• Before each use of this equipment inspect it according to the following
guidelines: A formal inspection of fall protection products/components must be
performed at least every six months by a competent person other than the user.
The frequency of formal inspections should be based on conditions of use or
exposure. Record the inspection results in the inspection and maintenance log
at the end of this manual. The component should be checked for Cut, Frayed,
Heavily Soiled, welding burns etc. Metal parts like D-rings should be duly check
for the crack, bent, deformities, corrosions etc.
9. LIMITATIONS:
• Tripod should be a personal property of its user.
• It should not be used in highly acidic or basic environments.
10. FITTING & SIZING:
The Tripod comes in two variants i.e. 7ft.(2.10) and 10ft (3.05). Depending on the
condition of usage one can choose best option as per
requirement.
STEP 1: Place the Tripod on the floor with the feet on the
ground. Remove the locking Pins from the head and
the legs.
STEP 2: Fully spread the legs and then replace the locking pins
on head to secure the legs in the open positions.
STEP 3: Resecure the locking pins into legs, after adjustment
of the required height or in fully extended position.
STEP 4: Place the Tripod over the entry point. Adjust the
Tripod as necessary by removing pins in one leg
at a time. Adjust each leg so the Tripod sits level
above user’s entry point. Ensure that all pins are re-installed.
STEP 5: Place the Retrieval Block on the opposite leg of the Tripod, where the
winch is installed.
SA 17W(7ft.) & (10ft.)
SA 17 (7ft.) & (10ft.)
R0006
R0006
