MegaPod User Instruction Manual
MaltaDynamics.com | 800-494-1840
12
Installation of retrieval block on megapod:
STEP 1 Locate the Tripod leg that has pre-installed mounting bracket for installing the
retrieval block.
STEP 2 Place the retrieval mounting bracket on the lower mounting bracket pre-installed
on the Tripod leg and insert the guiding pin into the slot. (refer fig. 2 and 3)
STEP 3 Use solid pin for locking the Retrieval Mounting bracket on pre-installed mounting
bracket of Tripod leg. (refer fig. 4)
STEP 4 Lock the solid pin on mounting brackets using cotter pin. (refer Fig. 4)
STEP 5 Insert retrieval block in bracket guided by aluminum guide provided on both side
of retrieval. (refer Fig. 5)
STEP 6 Lock the anchorage eye with bracket followed by solid pin and lock solid pin from
other end by inserting cotter pin. (refer fig. 6&7). Now the retrieval block is ready to be
used on Tripod (refer fig. 8)
13. OTHERS:
•
Maintenance & Cleaning:
Repairs to equipment can be made only by a Malta
Dynamics representative or person or entity authorized by Malta Dynamics.
Contact Malta Dynamics for maintenance and repair. Cleaning after use is
important for maintaining the safety and life of the equipment. Cleanse the
equipment of all dirt, corrosives, and contaminants. If the equipment cannot
simply be wiped clean use a mild soap and water. Rinse, wipe, and hang to dry in
shade.
•
Storage:
Store the anchorage connector component harness in a cool, dry and
clean place out of direct sunlight. Avoid areas where heat, moisture, light, oil,
and chemicals or their vapors or other degrading elements may be present.
Equipment which is damaged or in need of maintenance should not be stored
in the same area as usable equipment. Heavily soiled, wet, or otherwise
contaminated equipment should be properly maintained (e.g. dried and cleaned)
prior to storage.
Prior to using equipment which has been stored for long periods of time, a
Formal Inspection should be performed by a competent person. For harnesses
with Dielectric buckles, pass-thru buckles or Quick Connect Buckles, store the
harness with the buckles connected.
•
Training:
It is the responsibility of the users to assure that they read, understand,
and follow all instructions and are trained in the care and use of this device.
Training should be repeated periodically and any time there is a change of
components within the system. Training must be conducted without exposing the
trainee to a fall hazard
Installation of
on megapod:
retrieval block
fig.1
fig.2
fig.3
fig.4
fig.5
fig.6
fig.7
fig.8
Pre-installed
mounting
bracket
Retrieval
Mounting
bracket
(SA17(26)
Solid Pin
Cotter Pin
Retrieval block
Aluminium
guide
Solid Pin
Lock solid pin
by inserting
cotter pin.
