Imperial Carousel - Page 2
Glass Installation
Wear eye protection during the assembly of
this unit. Check all glass and parts for dam-
age. Replace any damaged parts prior to
continuing the installation. Do not assemble
this unit with any damaged parts. If you
should happen to break a glass panel, it must
only be replaced with ceramic glass.
Your Malm Carousel is supplied with Ceramic
High temperature glass. Side pannels are
10” x 14 ½ “ polish edge ceramic glass.
The door glass is 13 1/16 x 14 9/16 ceramic
glass. Replacement pannels are available
through Malm dealers are directly from Malm.
1. The door panel has had the latch assembly
and hinges installed at the factory. Remove
the hinges leaving the glued on plate in po-
sition.
2. Place the lower hinge in the hole in the fi re-
bowl, with the washer under it.
3. Insert the upper hinge into the hole at the
top of the door opening. Holding the upper
hinge in place, slide the glass door panel
into the hinges.
4. Hold the door panel in the closed position to
allow access to the hinge screws.
5. Maintaining a 1/8" clearance to the left door
post, tighten the screws in the hinges snug-
ly.
DO NOT OVER TIGHTEN
. Re-adjust as
necessary for proper alignment.
6. Note that two panels have gasket material
on one edge. These pieces go on either
side of the door. Make certain that these two
pieces are placed completly into the channel
on either side of the door. Failure to do this
will make the rest of the glass installation
impossible.
7. First loosen the glass retainers. This is a
metal strip secured by one screw in the mid-
dle. Start with the left door panel. The gasket
must be on the right side of the panel.
8. Slide the gasketed edge completely into the
channel on the side of the door. The left edge
of the glass should now fi t into the button at
the bottom of the glass.
9. Lower the glass into the lower glass clip.
10. Repeat steps 8 and 9 with the right door
panel. The gasket will be on the left side of
the panel with the not polished edge at the
top.
11. The remaining panels can now be installed.
The edge that is not polished is placed at the
top. As each panel is installed replace the
glass retainer in place but do not tighten.
12. After all the glass panels are installed center
the panels to reduce any gaps that may be
between the glass panels.
13.Tighten the glass retainers.
Hood
Retainer
and Screw
Glass
Lower Glass
Button
Upper Glass
Channel
