Malibu Boats Boat, User Manual, Page: 84 / 206

2-18
“WEDGE FAULT UNBALANCED” is a
signal from the Lenco box indicating an
actuator failure, alignment or fault.
“LOSS OF CAN SIGNAL” alarm occurs
when the CAN communication has
stopped.
The “ENGINE FAULT” warning is
triggered from engine ECM data.
The “CHECK TRANS” warning is
triggered from engine ECM data for
overheating.
“HIGH SPEED WEDGE DOWN” is
shown when the boat is going above 25
MPH with the wedge down.
A warning for the “WEDGE MOVING”
only appears when the wedge is moving up
past the wake zones.
The “WEDGE FAULT STARBOARD
ACTUATOR MAXED” is a signal from
the Lenco box indicating a starboard
actuator failure or fault.
The “WEDGE FAULT STARBOARD
ACTUATOR AVERAGE” is a signal from
the Lenco box indicating a starboard
actuator failure or fault.
“AUTO BILGE PUMP ON” will appear
whenever the auto bilge kicks on after the
ignition has been turned on.
Alert banner that a left or right surf button
has been pressed.
Caution banner for over speed with a Surf
Gate out. The gate will automatically retract
until speed has returned below 15 mph.
Error with Left RAM
Error with Left RAM
Error with Right RAM
Error with Right RAM
Chapter 2_15.qxp_ Chapter 2 doc.qxd 6/30/14 3:06 PM Page 18