Malibu Boats Boat, User Manual, Page: 133 / 206

2-67
Tower
Due to vibration and rough water conditions it is possible for
bolts to loosen. Before each use, inspect all mounting bolts
(Tower, Wakeboard Racks, Lights, Speakers, etc.) to ensure
they are tight. See your local dealer for any questions and/or
assistance. Failure to do so can cause serious damage and/or
injury to the boat and/or passengers.
Properly stow the bimini top in its boot and remove all boards from the board racks prior
to towing/trailering your boat. Speeds exceeding 50 MPH (80 km/h) with the bimini not
properly stowed may cause damage to the bimini top. Damage to the bimini from towing
while not stowed is not covered under warranty. Damaged or excessive wear to board
racks caused by towing or trailering with boards attached is not covered under warranty.
The tower is rated for a maximum of 130 lbs (58.9 kg) accessory weight and not more
than 600 lbs (272.1 kg) total rider weight. Exceeding these limits voids any structural
warranty pertaining to the tower. Approved activities for usage of the tower include
wakeboarding, wake skating, skiing or tubing.
Only factory pre-drilled holes should be used to install factory accessories on the tower.
The use of aftermarket accessories not supplied by Malibu Boats may cause damage not
covered by the tower warranty. Drilling any additional holes in the tower will void any
structural warranty.
Appropriate care must be taken to ensure the tower is not allowed to fall.
Towers are configured from the factory with shocks based on the factory-installed
components. If ANY additional components are mounted to the tower after the boat
leaves the factory, it is the dealer and the consumer’s obligation to validate that the
installed shocks and the tower are rated for these additional components.
The board rakes can be turned to the inside or outside of the boat, lowering its profile for
storage. Also, the rope bracket can be folded forward toward the mast light.
Illusion G3 Tower Option
The Illusion G3 has a solid foundation of billet aluminum bases and
billet tower support wings backing the 3" stainless steel hoop. The
Illusion G3 features dual gas spring shocks to assist in creating the
feature of weightless fold-down. The Illusion G3 tower is secured in
the UP position by two latches. To raise the tower, stand with your
back toward the bow of the boat. Raise the tower. Secure the tower in
position with the two tower latches.
!
WARNING
Figure 2-54. Tower
Latch
Chapter 2_15.qxp_ Chapter 2 doc.qxd 6/30/14 3:07 PM Page 67