- 19 -
TROUBLESHOOTING
SYMPTOM
CHECK ITEM
Cannot set to be 5.1ch output.
-If the speaker setup is incorrect.
The player does not play or displays
“NO DISC”.
-If the disc is not loaded in.
-If the disc is loaded upside down.
-If the disc is dirty or warped.
-If the local setup is not the same as the area code of
DVD discs.
-If water condensation have occurred.
If it occurs, take out the disc and leave the player on for
about one hour.
There is no sound.
-If the system connection is incorrect.
-If the speaker power is not turned on.
-If the audio setup of DVD discs is incorrect.
-If the disc is dirty or warped.
If it occurs, clean it or press it with books about 4-5kg.
There is no picture.
-If TV is not turned on or not in video mode.
-If the system connection is incorrect.
There is no picture in composite video
status.
-If the player is set in progressive scanning status.
If it is true, press “PS” button to shift the setup status.
Picture move up and down. Unsteady.
-If the signal system is incorrect.
If it is true, select correct system.
Cannot continue to play and play a
section repeatedly.
-If it is in A-B repeat status.
If it is true, press A-B button to cancel it.
-If the disc is dirty or damaged.
If it is true, clean it or select by time to skip the section.
The remote control does not work.
-If there are obstructions between the remote control
and the player.
-If you do not point the remote control at remote sensor.
-If batteries are not inserted.
-If batteries are weak.
If it is true, replace the batteries.
Others:
Static or other external interfere may cause the abnormity of the player. In this circumstance,
unplug the power-supply cord from the outlet and plug it in again to reset the player so that the
normal operation will be resumed. If you are still having problems, then please disconnect the
power and consult your service center or a qualified technician.
