- 17 -
SYSTEM SETUP
SPEAKER SETUP
The speaker setup is shown as following:
1. DOWNMIX (LT/RT, STEREO, VSS & OFF)
Select different item to output channel left/right signal, common stereo signal and
virtual surround signal respectively.
2. CENTER (ON & OFF)
3. REAR (ON & OFF)
4. SUBWOOFER (ON & OFF)
5. CNTR DELAY
6. REAR DELAY
7. TEST TONE (ON & OFF)
Select “ON” to test the tone of many channels in turn.
◆
Only when DOWNMIX is in “OFF” status, the setup of center, rear and subwoofer
speakers can be carried out. The center and rear speakers should be turned on
before setting “CNTR DELAY” and “REAR DELAY”.
AUDIO SETUP
The audio setup is shown as following:
1. AUDIO OUT (ANALOG, SPDIF/RAW & SPDIF/PCM)
Select “SPDIF/RAW”, and the amplifier should have source code or AC-3 decoding
function. Select ”SPDIF/PCM”, and the amplifier should have PCM or AC-3 decoding
function.
2. OP MODE (LINE OUT & RF REMOD)
You can select different item to do linear or radio frequency process to audio signal.
3. DUAL MONO (STEREO, L-MONO, R-MONO & MIX-MONO)
The function is used to set the output mode of channel left/right. DVD discs with
5.1ch will only be effective when setting to be “MIX-MONO”.
4. DYNAMIC
When “OP MODE” is set to be “LINE OUT”, select this item to adjust linear dynamic
compression rate to get different signal compression effects.
5. LPCM OUTPUT (LPCM 48K & LPCM 96K)
There are two sampling frequencies for selection.
