Maktek Omega 6, User Manual

Page: 7 / 19

2.3 CONTROL PANEL
•
ERROR CODES
H1
H2
H3
H4
H5
H6
EXPLANATION
Central Heating Sensor Error
DHW Sensor Error
Central Heating Circuit Low Water Pressure Error
High Temperature Measurement Error >= 95°C
Limit Thermostat Error
Heating Tank Water Level Error
This position is where the device is used for hot water usage. The desired
domestic hot water temperature is adjusted by turning the P1 key to the right.
The set temperature value flashes on the display. The seady numbers show
the current hot water temperature.
All functions required to run the boiler is done via two
buttons on control panel. These functions can be followed
on LCD screen. All failure reportings can be seen on
screen via specific codes.
1. P1 KEY
Domestic hot water function is OFF. In this position there is no hot water
production even when the hot water tap is opened.
TEST : Mode of adjustment by AUTORISED SERVICE during first installation
or maintance. Users should not use this position during operation.
2. P2 KEY
OFF-RESET :
The boiler is functionally switched off in this position.At failure times, it is
used as reset. Security measures such as anti-frost and jamming protection are active
in this position swueeze.
Winter Mode : Both DHW and heating function is on. Heating system
adjustments are made from P2 key. Desired temperature flashes on the
screen as you adjust with P2 key. The steady numbers show the current
heating water temperature. Primarily DHW is supplied.
Summer Mode :
Only DHW function is on. You can set this mode from P2
key when you do not need central heating. You can adjust the desired DHW
temperature by P1 key.
3. DIGITAL SCREEN
Shows operating parameters and errors occuring during operation with the warning
codes on the screen.
2.4 ERROR CODES
6