41
4 Operation
• Before operating the machine, make sure that the electrical installation was properly installed.
• The electrical installation should be done by a trained electrician.
• NOTE: Although your saw cuts wood and many other non-ferrous materials, we will limit ourselves
to discussing only the cutting of wood. The same guidelines apply to other materials.
• DO NOT USE ABRASIVE BLADES.
• The smoothness of any cut depends on a number of variables. Factors such as the type of
material being cut, blade type, blade sharpness and cutting rate contribute to the cutting quality.
• When you want smoother cuts for frames, install a sharper blade (80 or more carbonated teeth).
A slower and steady cut rate will produce the desired results. Make sure that the material does
not vibrate during the cut.
• The BMS.3200.IR cuts internal MDF sheets.
• Proper positioning of the body and hands during operation will make cutting easier, accurate
and more secure. Never place your hands close to the cutting area. Put your hands in position no
closer than 6 inches from the blade. Hold the piece firmly against the table and the guide during
cutting.
4.1 Cutting Setup
In the next session you will see how to make cuts with BMS.3200.IR.
4 Operation
