Fig. 50
Fig. 51
Assemble Carburetor by reversing the disassembly procedure carefully for the assembling order and direction of each part.
• Set Carburetor gasket in place so that the projection faces to the bottom side of Engine. (
Fig. 50
)
• Some specifications employ High speed needle. (Ask Makita authorized service center.) If yes, tighten the needle to
the full. After that, unscrew the needle one and five eighth turns. This is the starting position to do fine adjustment.
• Put the stopper on Inner cable end into Swivel, then adjust the hex nut so that the threaded top protrudes 4mm up to 5mm.
(
Fig. 51
)
Note
: Make sure that a play for Inner cable is adequate, and throttle can be fully pulled.
• After completing the repair, turn the idle-adjustment screw counterclockwise to adjust the engine idling speed to 2,800rpm
with 1$R070. (
Fig. 51
)
Face the projection of
Carburetor gasket to
the bottom side of Engine.
Stopper on Inner cable end
Cable bracket
Idle adjustment cable
TIPS OF ASSEMBLING
R
epair
P 1
4
/ 1
7
[4] DISASSEMBLY/ ASSEMBLY
[4]-11. Air cleaner assembly, Carburetor (cont.)
[4]-12. Stop switch
Fig. 52
Check the continuity between the bullet terminals on the two lead wires
extending from Control lever with a digital tester of 1R402. (
Fig. 52
)
If Stop switch functions properly,
there will be no continuity with the switch ON
and there will be continuity with the switch OFF.
1R402
CHECKING STOP SWITCH
the threaded top of
Control cable
Hex nut
Swivel
4mm up to 5mm
