Makita N3701, Instruction Manual

Page: 7 / 32

7
ENGLISH
Explanation of general view
SPECIFICATIONS
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END224-1
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.... Read instruction manual.
ENE010-1
Intended use
The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.
ENF001-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. This tool
should be grounded while in use to protect the operator
from electric shock. Use only three-wire extension cords
which have three-prong grounding-type plugs and three-
pole receptacles which accept the tool's plug.
GEA005-3
General Power Tool Safety
Warnings
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust.
Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool.
Distractions can cause you
to lose control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools.
Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators.
There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet
conditions.
Water entering a power tool will increase
the risk of electric shock.
1. Scale label
2. Clamp screw
3. Switch lever
4. Loosen
5. Tighten
6. Hold
7. Workpiece
8. Bit revolving direction
9. View from the top of the tool
10. Feed direction
11. Straight guide
12. Base protector
13. Screw
14. Base
15. Bit
16. Templet
17. Templet guide
18. Bolt
19. Guide plate
20. Flat washer
21. Wave washer
22. Wing nut
23. Clamp screw (A)
24. Center hole 25. Nail
26. Adjusting screw
27. Clamp screw (B)
28. Trimmer guide
29. Chip deflector
30. Guide holder
31. Guide roller
32. Trimmer shoe
33. Limit mark
34. Screwdriver
35. Brush holder cap
Model N3701
Collet chuck capacity 6.0 mm or 1/4"
No load speed (min
-1
) 30,000
Overall length 220 mm
Net weight 1.6 kg
Safety class Class I