Makita LD100P, Instruction Manual, Page: 39 / 410

14 Appendix
Makita LD100P
D
GB
F
I
E
NL
P
N
FIN
DK
S
TR
CZ
SK
PL
SLO
HR
H
GR
RUS
LV
EST
LT
ROK
CN
Storage of constants/historical
storage
Storage of a constant
You can store and recall a frequently used value e.g.
height of a room. Measure the desired distance,
press and hold the button until the device beeps
to confirm storage.
Recalling the constant
Press this button
once
to recall the constant
and make it available for further calculations by
pressing button .
Historical storage
Press this button
twice
and the previous 20
results (measurements or calculated results) are
shown in reverse order.
The and buttons can be used for navigation.
Press this button to use a result from the
summary line for further calculations.
Pressing the and buttons at the same time
erases all the values in historical storage.
Timer (self-triggering)
Press this button to set a 5-second time delay.
or
Press and hold down this button until the
desired time delay is reached (max. 60 seconds).
Once the key is released the remaining seconds until
measurement (e.g. 59, 58, 57...) are displayed in a
countdown. The last 5 seconds are counted down
with a beep. After the last beep the measurement is
taken and the value is displayed.
)
The timer can be used for all measurements.
Appendix
Message codes
All message codes are displayed with either or
"Error". The following errors can be corrected:
Cause Remedy
156
Transverse tilt
greater than 10° Hold the instrument
without any transverse
tilt
160
Main tilt direction,
angle too high
(> 45°) Measure angle up to
max. ± 45°
204
Calculation error Repeat procedure